HORN - MARKEN :: AUDIO RESEARCH :: AMPLIFIERS :: Reference 250 SE

Reference 250 SE

AUDIO RESEARCH

BLACK

NATURAL

Power output: 250 watts per channel continuous from 20Hz to 20kHz. 1kHz total harmonic Distortion typically 0.5% at 250 watts, below .04% at 1 watt. Approximate actual power available at "clipping" 270 watts (1kHz). (Note that actual Power output is dependent upon both line voltage and "condition" i.e. if power line has high Distortion, maximum power will be affected adversely, although from a listening standpoint this is not very critical.)
Power bandwidth: (-3dB points) 5Hz to 70kHz
Frequency response: (-3dB points at 1 watt) 0.5Hz to 110 kHz
Input sensitivity: 2.4V RMS Balanced for rated output. (25.5 dB Gain into 8 ohms.)
Input impedance: 200K ohms Balanced
Output taps: 4, 8, 16 ohms
Output regulation: Approximately 0.9dB 16 ohm load to open circuit (Damping factor approximately 10)
Overall negative feedback: 8.8dB
Slew rate: 20 volts/microsecond
Rise time: 1.5 microseconds
Hum & noise: Less than 0.2mV RMS – 110dB below rated output (IHF-A weighted, input shorted, 16 ohm output)
Power supply energy storage: Approximately 900 joules
Power requirements: 105-130VAC 60Hz (260-250VAC 50Hz) 770 watts at rated output, 1000 watts maximum, 380 watts at "idle," 1 watt off
Tubes required: 3 Matched pair KT150 (Power output V1-6); 1 Matched pair KT150 (Driver V8-9); 2 6H30 (Gain stage V7 and Regulator Driver V10); 1 6550C (Regulator V11)

Produktabmessungen: 483 x 222 x 495 mm

Nettogewicht: 33.20 kg

Minimale Bestellmenge: 1 Stk.

PREISE
DOKUMENTE
VERKAUF

PREISE

DOKUMENTE

VERKAUF

Teilen